Cement supply in Algeria

The high-temperature austenitic. 25Cr-20Ni gives scaling resistance to around 1035 C in continuous service, so 310S is the grade for furnace internals, radiant tubes and anything that lives in flue gas rather than in water.

Standard ultra high molecular weight polyethylene liner sheet. The lowest coefficient of friction of any engineering polymer combined with outstanding impact absorption.

Higher hardness plate for severe sliding abrasion where 450 HBW wears out too quickly, while retaining good workshop formability.

Enhanced UHMW-PE with a higher molecular weight delivering around 30% better abrasion performance than standard PE1000 for the most demanding liner duties.

The hardest abrasion resistant plate in general production, reserved for extreme sliding wear where part replacement downtime dominates cost.